Disassembly/Assembly Procedures GP Repair
wc_tx000549gb.fm 118
7.9 Replacing the Engine
See Graphic: wc_gr003141
Removal:
7.9.1 Disconnect the spark plug.
7.9.2 Remove the generator. See section Replacing the Rotor.
7.9.3 Turn the fuel valve (a) off. Remove the fuel hose (b) at the fuel valve;
plug the fuel hose as soon as it is free from the fuel valve.
7.9.4 Label and disconnect the wiring (c) running between the engine and
the control panel.
7.9.5 Remove the three screws (d) that secure the muffler guard to the
frame.
7.9.6 Remove the nuts (e) that secure the shockmounts to the frame (from
underneath) and pull the engine and muffler assembly (f) (including
shockmounts) from the frame.
Installation:
7.9.7 Position the engine and muffler assembly (f) into the frame. Secure it
to the frame with screws (e).
7.9.8 Secure the muffler guard to the frame with three screws (d).
7.9.9 Reconnect the wiring (c) running between the engine and the control
panel.
7.9.10 Reconnect the fuel hose (b).
7.9.11 Install the rotor and stator. See section Replacing the Rotor.
7.9.12 Reconnect the spark plug.
To Next Page
Loading...
Need help?
General
