Operation RD 7
36 wc_tx000294gb.fm
4.19 Operation on Slopes
See Graphic: wc_gr001346 and wc_gr001347
When operating on slopes or hills, special care must be taken to
reduce the risk of personal injury or damage to the machine. Always
operate the machine up and down hills rather than from side to side.
For safe operation and for protection of the engine, continuous duty
use should be restricted to slopes of 22° (40% grade) or less.
NEVER operate the machine sideways on slopes. The machine may
roll over, even on stable ground.
4.20 Rollovers
Proper operation of the machine on slopes will prevent rollovers. Read
and follow Safety instructions in “Operating Safety” and “Operation on
Slopes”. If a machine rollover does occur, care must be taken to
prevent damage to the engine. In this position, oil from the engine
crankcase can flow into the combustion chamber, which can severely
damage the engine next time it is started. If the machine has rolled on
its side, immediate steps should be taken to right the machine.
NOTICE: To prevent damage to the engine after a rollover, the
machine must NOT be started, AND it must be serviced to remove any
oil that may have been trapped in the combustion chambers. Contact
your local Wacker Neuson dealer for instructions or servicing.
WARNING
22˚
40%
wc_gr001346
wc_gr001347
To Next Page
Loading...
Need help?
General
