13
EPG-SPRINT.
OPERATING MANUAL
VERSION 08/2010
ORDER NUMBER DOC 2305222
4 DESCRIPTION
4.1 FIELDS OF APPLICATION, USING IN ACCORDANCE WITH THE INSTRUCTIONS
The EPG-SPRINT control unit can be used as a stand-alone unit in manual coating systems
or can be connected to the PrimaTech automatic system together with other units.
● When a Corona gun is connected, Corona current scale and the high-voltage supply
and control unit are active.
● When a Tribo gun is connected, the Tribo current scale is activated, while the
high-voltage supply and control unit are deactivated.
The control unit recognizes whether a manual or automatic spray gun is connected.
If an automatic gun is connected, then the control unit can only be controlled via the
CCM Prima interface.
The following powder coating guns can be connected to the EPG-SPRINT:
Manual spray guns
● Corona spray gun PEM-C3, PEM-C4, PEM-C4-Ergo
● Tribo spray gun PEM-T3
Automatic spray guns
● Corona spray gun PEA-C3, PEA-C4
● Corona spray gun PEA-C3XL, PEA-C4XL
● Tribo spray gun PEA-T3
● Tribo spray gun PEA-T3XL
● Angled spray gun PEA-C3A, PEA-C4A (not PTB approved)
Older or other gun types may only be connected to the control unit after fi rst checking
their suitability with Wagner.
WARNING
Incorrect use!
Risk of injury and damage to the equipment.
➞ Only connect original Wagner spray guns to the EPG-SPRINT
control unit.
➞ The PEM-C3R and PEM-T3R manual spray guns cannot be
connected to the EPG-SPRINT control unit.
To Next Page
Loading...
Need help?
General
