WAGNER EPG-SPRINT - Activate High Output Mode (C17)

31
EPG-SPRINT.
%
Tribo Corona
5
4
3
2
1
120
100
80
60
40
30
20
15
10
5
μA
μA
0
10
20
30
40
50
60
70
80
90
100
Ø
12
10
11
9
8
m
/h
5.0
4.0
3.0
2.0
6.0
3
5.5
4.5
3.5
2.5
2.2
kV
90
80
70
60
50
40
30
20
10
100
m /h
4.0
3.0
2.0
1.0
0.5
0.4
0.3
0.2
0.1
1.5
%
Tribo Corona
5
4
3
2
1
120
100
80
60
40
30
20
15
10
5
μA
μA
0
10
20
30
40
50
60
70
80
90
100
Ø
12
10
11
9
8
m /h
5.0
4.0
3.0
2.0
6.0
3
5.5
4.5
3.5
2.5
2.2
kV
90
80
70
60
50
40
30
20
10
100
m /h
4.0
3.0
2.0
1.0
0.5
0.4
0.3
0.2
0.1
1.5
%
Tribo Corona
5
4
3
2
1
120
100
80
60
40
30
20
15
10
5
μA
μA
0
10
20
30
40
50
60
70
80
90
100
Ø
12
10
11
9
8
m /h
5.0
4.0
3.0
2.0
6.0
3
5.5
4.5
3.5
2.5
2.2
kV
90
80
70
60
50
40
30
20
10
100
m /h
4.0
3.0
2.0
1.0
0.5
0.4
0.3
0.2
0.1
1.5
EPG
S
P
R
I
NT
EPG
S
P
R
I
N
T
EPG
S
P
R
I
NT
P_01124
OPERATING MANUAL
VERSION 08/2010 ORDER NUMBER DOC 2305222
6.3.2 ACTIVATE HIGH OUTPUT MODE (C17)
Procedure:
1. To access special device confi guration,
switch the unit to “standby“ with the
“standby“ button 15. The yellow
“standby“ LED 16 lights up.
2. Press “characteristic slope“ button 31 and
hold it down.
3. With your other hand, turn the Universal
rotary controller 24 until “10“ appears
in the LED display 19. Then release the
“characteristic slope“ button 31. The
device is now in confi guration mode. The
scrolling text “confi guration“ is displayed.
19
24
4. The LED display 19 now shows the
fi rst confi guration setting C11. At the
same time, the two yellow LED displays
“high-voltage“ 28 and “spray current“ 30
will fl ash.
16
15
19
28
30
31