64
EPG-SPRINT.
2x
2x
OPERATING MANUAL
VERSION 08/2010 ORDER NUMBER DOC 2305222
1 CHANGING THE PARAMETERS
1. Use selection button to select the parameters required.
The yellow LED lights up.
2 CALLING / CHANGING / SAVING PROGRAMS 1-4
1. Select the program you want by pressing the corresponding program button.
2. Set new parameters (electrostatic, air quantity) (see 1).
3. Press the program button required for around 2 seconds until the LED fl ashes rapidly.
The program is saved with new parameters and can be called up again at any time at
the touch of a button!
3 CALLING / CHANGING / SAVING PROGRAMS 5-50
1. Press additional programs button.
2. Set program number with rotary controller.
The program number is shown in LED display.
3. Set new parameters (see 1).
4. Press additional program button for around 2 seconds.
The changed parameters are saved.
5. The program number is shown fl ashing in LED display.
6. Set program number required with rotary controller.
(Only necessary if the parameters are to be saved under another program number.)
7. Press additional program button for around 2 seconds.
8. LED display fl ashes quickly.
Program is saved with new parameter!
Operation of the control unit
2. Set parameter value with rotary controller.
The value set is shown in LED display.
To Next Page
Loading...
Need help?
General
