60
EPG-SPRINT.
OPERATING MANUAL
VERSION 08/2010
ORDER NUMBER DOC 2305222
Parameter Value Designation
C11 Gun charging type
cor
(factory setting)
Wagner Corona guns can be connected to
the unit; a Tribo gun will trigger a fault.
tri Wagner Tribo guns can be connected to
the unit; a Corona gun will not trigger a
fault.
aut Tribo or Corona guns can be connected
to the unit. The system only changes to
the correct type after it is fi rst switched on
with the gun‘s trigger or the connected
CCM control module.
C12 Selection reset function
OFF The selection function is switched off. A
selection is retained until another
selection is made.
ON
(factory setting)
Selection function is switched on: after
5 seconds, the selection automatically
returns to the powder quantity setting.
C13 Lock
OFF
(factory setting)
Lock is switched off.
ON Lock is activated, values cannot be
changed, user can only select programs
and control functions.
Program values cannot be changed.
C14 “Double click“ function
OFF “Double click“ function is switched off.
ON
(factory setting)
The “double click“ function is switched on
- when the manual gun‘s trigger is pressed
twice to switch on, the program jumps
to the “double click“ program; at the next
switch-on the previous recipe is selected
again.
C15 Operating hours counter
only display The effective coating hours are counted.
The numerical value shown should be
multiplied by 100.
Examples:
0.15 ➔ 0.15 * 100 h = 15 opertaing hours
050 ➔ 50 * 100 h = 5000 operating hours
Table of parameters
To Next Page
Loading...
Need help?
General
