21
T090, T092.
OPERATING MANUAL
EDITION 01 /2014 PART NO. ZZB022ENG
Pressure regulator has been tested with oil. Before using it, it is advisable to clean it by
pumping an adequate solvent to remove all residues of this liquid or other residues that
could have entered during the assembling phase.
NOTE: In case liquids subject to chemical hardening (such as catalysed resins) are used, at
the end of the work it is recommended to carefully wash the pressure reducer by means of
a solvent adequate to that particular kind of resin, leaving the reducer full of solvent when
not in use.
5.2.2 CLEANING
To Next Page
Loading...
