23. Environmental protection
The device and all accessories and packaging have to be recycled in an
environmentally friendly manner. Do not dispose of the appliance with
household waste. Support environmental protection by taking the appliance
to a local collection point or obtain information from a specialist retailer.
Leftover paint and solvents may not be emptied into drains, the sewage system
or disposed of as household rubbish. It has to be disposed of separately as
special waste. Please pay special attention to the instructions on the product
packaging.
24. Important Note regarding Product Liability!
According to an EU directive, the manufacturer is only liable without limitation for faults
in the product if all parts come from the manufacturer or have been approved by the
manufacturer and have been mounted to the device and are operated properly. If third-
party accessories or spare parts are used, the manufacturer is exonerated wholly or partly
from his/her liability if use of the third-party accessories or spare parts have caused a
defect in the product.
25. Correction of Malfunctions
Malfunction Cause Remedy
No coating
material emerges
from the nozzle
•
Nozzle clogged
•
Material volume setting turned too
far to the left (-)
•
No pressure build-up in container
•
Container empty
•
Feed tube loose
•
Feed tube clogged
•
Ventilating bore (Fig.14,A) clogged
➞ Clean
➞ Turn to the right (+)
➞ Tighten container
➞ Rell
➞ Insert
➞ Clean
➞ Clean
Coating material
drips from the
nozzle
•
Coating material assembly at air
cap, nozzle or needle
•
Nozzle loose
•
Nozzle seal worn
•
Nozzle worn
➞ Clean
➞ Union nut tighten
➞ Change
➞ Change
To Next Page
Loading...
