Why my Walgreens Blood Pressure Monitor does not turn on?
If your Walgreens Blood Pressure Monitor isn't turning on when you press the START/STOP button, the batteries may be depleted. Replace them with new alkaline batteries. Also, check the battery polarities and re-insert the batteries in the correct positions.
What to do if Walgreens Blood Pressure Monitor displays EE error?
If your Walgreens Blood Pressure Monitor displays an 'EE' error or shows an abnormal blood pressure value, it could be due to a few reasons. Make sure you wrap the cuff properly and position it correctly before measuring again. Also, keep your wrist steady during measurement, avoiding any talking or movement. If your wrist was shaking with the cuff on, try measuring again.
What does EP error mean on Walgreens WGNBPW-710 Blood Pressure Monitor?
If your Walgreens Blood Pressure Monitor is showing an 'EP' error symbol, this indicates a system error. In this case, measure again.
General| Model Number | WGNBPW-710 |
|---|---|
| Brand | Walgreens |
| Category | Blood Pressure Monitor |
| Type | Upper Arm |
| Memory | 60 readings |
| Display | LCD |
| Irregular Heartbeat Detection | Yes |
| Automatic Shut-off | Yes |
| Measurement Range | 0-299 mmHg |
| Cuff Size | 9" to 17" (23 cm - 43 cm) |
Explains the importance of monitoring blood pressure due to common health problems.
Provides defined hypertension levels from NIH for comparison.
Explains symbols like Weak Battery, IHB, and error codes.
Lists conditions for battery replacement and care instructions.
To Next Page