Walgreens WGNBPW-710 - Troubleshooting

28
Note: If the unit still does not work, contact HoMedics Consumer
Relations. Under no circumstance should you disassemble or
attempt to repair the unit by yourself. Contact information for
HoMedics Consumer Relations Department can be found on
the warranty page.
SYMPTOMS
POSSIBLE
CAUSES
CORRECTION
Unit does not
turn on when the
START/STOP
button is pushed.
Batteries have
run down.
Replace them
XJUIUXPOFXi"""w
alkaline batteries.
Battery polarities
have been positioned
incorrectly.
Re-insert the
batteries in the
correct positions.
EE measurement
error symbol shown
on display or the
blood pressure
value is displayed
FYDFTTJWFMZMPX
(or high).
Cuff has been placed
incorrectly.
Wrap the cuff properly
so that it is positioned
correctly. Measure again.
Did you talk or
move during
measurement?
Keep wrist steady during
measurement. Measure
again.
Shaking of the wrist
with the cuff on.
&FSSPSTZNCPM
shown on display
Air circuit
abnormality.
Measure again.
&FSSPSTZNCPM
shown on display
Inflation pressure
FYDFFEJOHNN)H
Switch the unit off, then
measure again.
&FSSPSTZNCPM
shown on display
Error determining
measurement data.
Measure again.
EP error symbol
shown on display
System error. Measure again.
TROUBLESHOOTING
If any abnormality arises during use, please check the following points: