26
ELECTROMAGNETIC COMPATIBILITY (EMC)
t (VJEBODFBOENBOVGBDUVSFSTEFDMBSBUJPOoFMFDUSPNBHOFUJDFNJTTJPOT
The device is intended for use in the electromagnetic environments listed below, and should only be
used in such environments:
Emissions test Compliance &MFDUSPNBHOFUJDFOWJSPONFOUoHVJEBODF
3'FNJTTJPOT$*413 (SPVQ RF energy is used only to maintain device’s operation.
Therefore, its RF emissions are so low that it’s not
likely to cause any interference in nearby electronic
FRVJQNFOU
3'FNJTTJPOT$*413 Class B
Harmonic emissions IEC
Not
Applicable
The device is suitable for use in all establishments,
including domestic establishments, and those directly
connected to the public low-voltage power supply
network that supplies buildings used for domestic
purposes.
7PMUBHFnVDUVBUJPOT
nJDLFSFNJTTJPOT*&$
Not
Applicable
t(VJEBODFBOENBOVGBDUVSFSTEFDMBSBUJPOoFMFDUSPNBHOFUJDJNNVOJUZ
The device is intended for use in the electromagnetic environments listed below, and should only be
used in such environments:
Immunity test IEC 60601 test level Compliance level &MFDUSPNBHOFUJDFOWJSPONFOUo
guidance
Electrostatic
discharge (ESD)
*&$
ßL7DPOUBDU
ßL7BJS
ßL7DPOUBDU
ßL7BJS
Floors should be wood, concrete
PSDFSBNJDUJMF*GnPPSTBSFDPWFSFE
with synthetic material, the relative
IVNJEJUZTIPVMECFBUMFBTU
1PXFSGSFRVFODZ
)[
magnetic field
*&$
"N "N 1PXFSGSFRVFODZNBHOFUJDmFMET
should be at levels characteristic of
a typical location in a typical com
-
mercial or hospital environment.
t 3FDPNNFOEFETFQBSBUJPOEJTUBODFTCFUXFFOQPSUBCMFBOENPCJMF3'DPNNVOJDBUJPOFRVJQNFOU
and the device.
The device is intended for use in an electromagnetic environment where radiated RF disturbances are
under control. User can help prevent electromagnetic interference by keeping the device at a minimum
EJTUBODFGSPNQPSUBCMFBOENPCJMF3'DPNNVOJDBUJPOTFRVJQNFOUUSBOTNJUUFST#FMPXUBCMFEFUBJMT
UIFNBYJNVNPVUQVUQPXFSPGUSBOTNJUUFS
Rated maximum
output power of
transmitter W
4FQBSBUJPOEJTUBODFBDDPSEJOHUPGSFRVFODZPGUSBOTNJUUFSN
L)[UP.)[
Not Applicable
.)[UP.)[
E
.)[UP()[
E
NA
NA
NA
NA
NA