Walker H38i - Engine;Pto Belt

64
Maintenance Instructions REPLACING/REPAIRING
Engine/PTO Belt
1. To remove an engine/PTO belt:
a. Remove Upper LH Belt Guard and RH Belt
Guard by removing two (2) wing nuts.
b. Remove two (2) wire lock pins and open
Lower LH Belt Guard and PTO Belt Guard.
c. Roll the belt off the pulley( and remove the
belt.
Engine/PTO Belt (Belt Guards Open) (Engine Hidden for Clarity)
2. To replace an engine/PTO belt:
a. Reverse the removal procedure to replace
an engine/PTO belt.
b. Secure wire on lock pin above tab on lower
PTO guard.
Engine/PTO Belt (Belt Guards Closed) (Engine Hidden for Clarity)
PTO GuardSecure Wire Above Tab
Front View
Right Hand
Guard
Secure
Wing Nut
Lower LH
Guard
Wire Lock
Pin
Upper LH
Guard
Secure
Wing Nut
PTO Guard
Wire Lock Pin
Wire Lock Pin
PTO Belts
(Matched Set)
Fixed Idler
Pulley
Lower LH
Guard
Upper LH
Guard
Right Hand
Guard
Clutch
Idler Pulley
Wing
Nut
Wing
Nut
PTO
Pulley