Walker H38i - Blade Drive; Tire Size; Tire Pressure; DIMENSIONS (Tractor and Mower)

Specications
4
MODEL H38i
TRANSMISSION (continued)
Transmission Fluid
Factory Service 20W50 MultiViscosity Motor Oil (Minimum SL Grade Oil)
Transmission Oil Capacity  oz (L) 77 (2.3)
Transmission Cooling Cooling Fan Mounted on Drive Pulley
Oil Filter HydroGear
®
P/N 52114 (Walker P/N 20266)
Ground Travel Speed
Forward MPH (km/h)
Reverse MPH (km/h)
010 (016) Innitely Variable
05 (08) Innitely Variable
BLADE DRIVE
PTO Shaft Sliding Spline Shaft with Two (2) HighSpeed UJoints
(Quick Disconnect)
Blade Drive Clutch and Brake Manual Belt Tightener Clutch and Band Brake
[Stops Blades within Five (5) Seconds of Disengagement]
TIRE SIZE
Deck Caster Wheel 13 x 5.006 (Pneumatic 4Ply)
Drive 22 x 10.5012 (4Ply LowProle)
Tailwheel 13 x 5.006 (Pneumatic 4Ply)
TIRE PRESSURE PSI (KPA)
Deck Caster Wheel 20 (137)
Drive 15 (103)
Tailwheel 20 (137)
DIMENSIONS (Tractor and Mower)
Length in. (cm)
Tractor Only 69 (175)
Tractor Wheel Base 45 (115)
Tractor with Tilted Deck
(Approximate)
87.75 (223)
Tractor with 64" Rear Discharge
Deck (DR643)
107.75 (274)
Width in. (cm)
Tractor Only (Outside Tire) 46.5 (118)
Tractor with 64" Rear Discharge
Deck (DR643)
66 (168)
Tread Width 36.5 (93)
Height in. (cm)
Tractor 46.5 (118)
With ROPS (Optional) 66.25 (168)
With ROPS (Optional) Lowered 51.25 (130)