717=5E.T
Quick Start Guide
RETURN TO HOME
_
Height over HP >15m
Elevate to 15m
Throttle stick
neutral
MIX switch to
"2" position
Home Pt
9
Height over HP< 15m
a.
If the flight altitude is higher than 15m, the aircraft will keep the current altitude and return above the Home Point then
descend vertically.
b.
When the flight altitude is lower than 15m, the aircraft will elevate automatically to 15m then fly back above the Home
Point and land vertically.
Attention:
(1)
Enable that you've received GPS signals well (Left red LED light blinks).
(2)
After engaging Return to Home mode, leave the throttle stick at 50% (centered) DO NOT touch any switches on the Remote
Controllers. To REGAIN control of the Runner 250, make sure the throttle is centered, then flip the MIX switch to position "0" .
In an emergency such as losing the control link between the Remote Controllers and the Runner 250, the Failsafe system will
automatically start RTH.
You may not be able to interupt an emergency RTH, simply let the aircraft continue until it lands.
(3)
When in the process of RETURN TO HOME, if the battery voltage is too low, the aircraft will fall, but can't automaticly return,
please control the aircraft direction manually, till the aircraft land safely.
Dream Baron
Attention:
(1)
Dream Baron is more suitable for experienced pilots.
(2)
During the flying, please keep in sight of 50 meters or video control
range within 300 meters to control the flight.(Actual range depending on the flight environment and weather conditions.)
(3)
During the flying, please avoid obstacles such as people, animals and power lines.
When the right-rear red LED light flash slowly, means the battery voltage is too low,
the aircraft will fall.
9.0 End flight
0 Manual landin
g
or return to home function landin
g
.
0 First, power off aircraft battery, then power off Remote Controller battery.
® Take the battery out of aircraft.
-13-
To Next Page
Loading...
