Walkera Runner 250 - 7.0 Ready for flight; 7.1 Binding of the Runner 250

`
LET
Quick Start Guide
7.0 Ready for flight
n
i Attention:
(1) Place the aircraft on a flat surface, in an open space, with the back facing you.
(2) Put all the function switches to the 0 position, put all trims/knobs to the Middle
position, move the throttle to the lowest position, then turn on the Remote Controller.
7.1 Binding of the Runner 250
0 Turn on the Remote Controller. (Make sure
all the function switches, all trims/kobs and
throttle stick at the correct position)
0 Put the aircraft to the horizontal place and
connect the aircraft power. (make sure the
positive and negtive connected correctly )
g After 5 sec. the right red LED light will stop
flashing indicating that the code binding has
finished. (Note: When binding, do not move
the runner 250.)
-8-