boots are made from a specially engineered polymer. They are composed of
one rigid layer which is very thin and durable, but not very absorbent (does not hold liquid). This may require
additional Surfox-T solution to keep the boot wet during cleaning.
They are used for internal angles or tight corners because they are thinner
and reduce the chance of arcing.
wrap around the insert, they avoid short circuits (arcing).
Several shapes and sizes are available:
For large flat internal surfaces or angles.
To be used with tungsten insert 48-R 133.
For narrow flat internal surfaces or angles.
To be used with tungsten insert 54-B 017.
For large internal corners or angles.
To be used with tungsten insert 54-B 016.
Narrow Cleaning boot 60º:
For narrow internal corners or angles.
To be used with tungsten insert 54-B 018.
To Next Page
Loading...
