23. Do not touch the wand tip or work piece while working or immediately after use, they may be extremely
hot and could cause serious burns.
24. Do not abuse the power cord. Never pull or lift this unit by its cord or yank to disconnect it from the
receptacle. Keep the cord away from heat, oil and sharp edges. Inspect the cord periodically, if damaged,
have it replaced by a WALTER Factory Service Center or a WALTER Authorized Service Center.
25. When not in use, switch OFF and unplug the electrical cord and air hose. It must also remain unplugged when
replacing cleaning pads and other accessories, while performing maintenance and before servicing.
26. Store the unit in a dry safe place, out of the reach of children and other unqualified persons.
Before connecting this unit, check that the voltage shown on the rating plate is the same as that of the power
Operating this unit on a voltage other than specified on its rating plate may result in personal in
Operating this unit on a voltage other than specified on its rating plate may result in personal injury to the Operating this unit on a voltage other than specified on its rating plate may result in personal in
After use, allow the tip to cool and remove the cleaning pad. Rinse the cleaning pad and wand tip with water
and dry. Clean dust and dirt deposits from the exterior of the unit. Keep all airflow vent openings free of any
obstructions. Clean the power cord to prevent deterioration and check for possible damage to cord and plug.
Damaged cords must be replaced immediately by qualified personnel only. Refer to Spare Parts List for
Before transporting the machine, make sure the cleaning solution reservoir and supply line are completely empty
and all connecting lines disconnected. The machine must be carefully packed in a suitable container and properly
will not be held responsible for any damages resulting from leaked cleaning solution or
WALTER will not be held responsible for any damages resulting from leaked cleaning solution or WALTER
If the machine is to be stored for any length of time, the cleaning solution reservoir and supply line must be
emptied, cleaning pad removed (rinsed and left off) and the tip rinsed and dried. Store in a dry safe place to avoid
damage, especially to the electronic components.
Dispose of residual waste in compliance with Federal, Provincial, State and local environmental regulations.
Refer to WALTER Material Safety Data Sheet for Surfox-T #S-01E.
When an extension cord is needed, use wire size 14 (AWG) for up to 50 feet (15 meters) and size 12 (AWG) for 50
to 100 feet (15 to 30 meters).
To Next Page
Loading...
