Walther Systemtechnik S11 series - Dimensioned Drawing of SMS-11 with Clamping Holder (Standard); Dimensioned Drawing of SMS-11 with Quick-Change Board (Standard)

Rev. 1.4
Assembly Instructions – Spray Valve SMS-11
Page 19 of 28
Walther Systemtechnik GmbH – D 76726 Germersheim
Telefon: +49 (0)7274-7022-0 Telefax: +49 (0)7274-7022-91
http://www.walther-2000.de – info@walther-2000.de
9.1.1 Dimensioned Drawing of SMS-11 with Clamping Holder (Standard)
The clamping holder is an easy way of fastening the spray valve (e.g. on a shaft). The clamp holder will be
attached to the spray valve with two screws.
9.1.2 Dimensioned Drawing of SMS-11 with Quick-Change Board (Standard)
A quick-change board (with supply line for air material supply) was designed for a fast mounting/dismounting
of the valve. The board/adapter comes with a locking device and a banjo screw for attaching the spray valve.