Why does my Waltron 3041 show Emergency Stop?
The Emergency Stop button was activated. You need to figure out why the Emergency Stop was pressed and fix the issue. After that, press the RESET button on the RUN window.
What to do if Waltron Analytical Instruments shows Reagent
If your Waltron Analytical Instruments analyzer displays 'Reagent
What to do if there is Loss of Sample 1 in Waltron Analytical Instruments?
If you are experiencing a 'Loss of Sample 1' error with your Waltron Analytical Instruments, the sample to stream 1 is lost. You should check the flow of Sample #1.
What to do if there is Loss of Sample 2 in Waltron 3041 Analytical Instruments?
If you are experiencing a 'Loss of Sample 2' error with your Waltron Analytical Instruments, this means the sample to stream 2 is lost. Check the flow of Sample #2, keeping in mind that this applies to Dual stream analyzers only.
General| Power Supply | 100-240 VAC, 50/60 Hz |
|---|---|
| Number of Burettes | 2 |
| Burette Volume | 10 mL, 20 mL, 50 mL |
| Measurement Range | pH: 0-14; mV: ±2000 mV |
| Accuracy | ±0.1 mV |
| Resolution | 0.1 mV, 0.001 pH |
| Operating Temperature | 5°C to 40°C |
| Dimensions | 300 mm |
To Next Page