WANHAO Duplicator 8 MARK I - Printer Preparation: Platform Mounting Guide; Mounting and Securing Printing Platform

AFTER SALES SUPPORT
86-571-23290996
support@wanhao3dprinter.com
Model : Duplicator 8 MARK I
17
6.0
Mounting printing platform
6.1
Mount the printing platform on the holding plate and tighten
two knobs on top of it, Make sure is tight enough that the printing
platform does not move or shake.
6.2
Loosen four knobs on the printing on the right and
the left side of the platform.