WANHAO MARK II Duplicator 6 Plus

Need help?

Do you have a question about the WANHAO MARK II Duplicator 6 Plus and is the answer not in the manual?

Summary

Installing Parts on Your WANHAO D6 Plus

First Use of Your WANHAO D6 Plus

First Time Startup

Guides through initial printer setup and the first run wizard using the display.

Leveling the Build Plate

Instructions for performing automatic and manual bed leveling for optimal prints.

Loading Filament Material

Step-by-step guide on how to load filament into the printer's material feeder.

Make Your First 3 D Print

Instructions on preparing the printer and starting the first 3D print job.

Resume Printing After Power Failure

3 D Printing and Print Removal

How to monitor the printing process, understand the display, and safely remove finished prints.

Make a Printfile with Cura Software

Preparing a 3 D Model

From SD-card to Print Your File

Maintenance for Your WANHAO D6 Plus

Change Filament and Material Feeder

Troubleshooting and Support for the WANHAO D6 Plus

Simple Troubleshooting Tips

Offers solutions for common printing problems like print detachment and material feeder issues.

Contact Support

Safety and Compliance

Important safety warnings and compliance information for using the product.