CURA WANHAO EDITION USER MANUEL REV.B 18 / 23
Make basic changes at specified Z heights. You can determine the Z height or layer count at which
you want to make a change. Then choose how you would like to change your settings. You can
alter temperatures, fan speeds, and print speeds. Fine tuning these for specific STL files, can
produce cleaner prints.
Pause at Z Height
Pause your print at a specified height. You can also specify where to move the print head and
how much filament to retract. This will prevent “lobs” from accumulating on your print while
paused. This setting is most commonly used when switching colors of filaments in the middle of a
print.
1.11 Start and End Gcode Settings
Custom Gcode allows for complex automatic printer movements and operations. By adding
custom Gcode into the start or end of you rfile, you can alter how it prints. A comprehensive list
of Gcode commands can be found here: http://reprap.org/wiki/G-code Were commend new
users to leave this as provided in the profiles at
http://www.wanhao3dprinter.com--download.
1.12 Expert Settings
Expert settings will give you more specific options for your retraction, skirt, active cooling, infill,
support, brim, raft, and special settings. To gain access to this section you go to Expert > Open
Full Settings or on your keyboard press Control + E.
Figure 1.21: View Expert Settings
1.13 Retraction
Retraction pulls filament out of your nozzle when it is not extruding to prevent your print head
from dripping on your object. This section is where you will control how your extruder retracts its
To Next Page
Loading...
