Water Right Impression - Service;OEM SOFTENING Screens (continued); Additional Cycle Positions; Draw Time Setting

6
cont’d
CYCLE 4
REGENERANT DRAW DN
SET
90:00
MIN
DRAW TIME
SET
CYCLE 5
RINSE
SET
4:00
MIN
RINSE TIME
SET
CYCLE 6
END
SET
11
12
13
14
15
Service/OEM SOFTENING Screens
Accessed by pressing and holding NEXT and — simultaneously for three seconds.
Returns to general display after five minutes of inactivity.
Set fourth cycle position with + or — buttons.
Set draw time with + or — buttons.
Default setting is 90:00 minutes.
Set fifth cycle position with + or — buttons.
Set final rapid rinse time with + or — buttons.
Default setting is 4:00 minutes
Set end cycle with + or — buttons.
Up to fourteen cycle positions may be programmed into
a regeneration. An END position triggers the end of a
regeneration and a return to service.
continued from previous page
Return to general display