Unscrew the filter body from the filter head by turning the
base in a counter-clockwise direction.
Pour away the excess water.
Replace the filter cartridge into the filter head as shown.
Screw the filter body to the filter head, making sure it’s
securely tightened.
Fit the filter assembly into the machine as follows:
Insert the filter assembly back into its cradle, aligning the
two male spigots with the female holes in the cradle
Push it firmly until the filter sits snugly and is flush with the
cradle top surface
Lock the filter by closing the locking lever until it ‘clicks’
into place
CUBE Operating, Installation, and Service Manual Page 50 - Revision: 6-23-2015
To Next Page
Loading...
