31.
Use a Phillips-head screwdriver to reinstall the two screws
at the rear of the machine that secure the top panel.
32.
Turn on the water supply at the isolation point.
Reconnect the power lead and insert it into the rear of the
machine. Turn On the Red Power Switch I=ON
The Green Heater/Compressor switch can now be turned
on. Allow the Cube to heat and cool the water.
Clean the outside of the machine with the non-abrasive anti-bacterial wipe or cloth.
Taste the water one final time, if you detect hint of taste, flush 3 more galls of water through
the Hot Tank.
WARNING! HOT WATER HAZARD. Unit Produces Very Hot Water and Steam. Always use
insulated and chemically compatible containers and let unit cool down before draining the hot tank
to avoid injury.
CAUTION! REPLACE HOT TANK EVERY 5 YEARS. The hot tank and its controls should be
replaced a minimum of every five years to ensure efficient operation.
WARNING! REINSTALL ALL PANELS AND COVERS. Always reinstall all panels, protective covers,
and fasteners after servicing equipment. Failure to do so could result in severe personal injury and
will void the certifications and warranty of the equipment.
CUBE Operating, Installation, and Service Manual Page 51 - Revision: 6-23-2015
To Next Page
Loading...
