WL2FLT Manual Page 20 – Revision 10-26-2021
PROGRAMMING INSTRUCTIONS
DISABLING ENERGY SAVING SLEEP MODE
All WL2FLT Water Treatment Systems come from the factory with Energy Saving Sleep Mode
engaged to meet the Energy Star Certification requirements. Energy Saving Sleep Mode disables
the heater circuit if the unit has not been used for a continuous 3 hour or longer period.
Selecting any button "wakes up" the WL2FLT Water Treatment System and turns the heater
circuit back on. The hot tank will typically take less than 10 minutes to heat the water from
ambient to the 85°C (185°F) set point.
Unplug Power Cord and remove Top Cover to access back side of the Display PCB.
WL2FLT Water Treatment Systems comes with the
Energy Saving Sleep Mode “ON” - the Default Position.
DIP 1 in the "ON" position (up).
To Next Page
Loading...
