13 PB0347:m-620atex-en-03
Fitting the rotor
l Check and clean the driveshaft using a mild detergent and damp cloth.
l Remove the cover from the new rotor. Examine the rotor to ensure that the "A" symbol appears on
the rotor as shown below. If there is not an "A" symbol on the rotor then DO NOT fit this part and
contact Watson-Marlow aftersales for the correct ATEX component. Any letter other than an "A"
indicates that the rotor is not suitable for ATEX applications and if fitted may result in an electrostatic
hazard.
ATEX Rotor
ATEX Rotor is marked with an "A" in position
shown
To Next Page
Loading...
