WAVECONTROL SMP User Manual

4.2.2 Disconnecting the probe
You do not need to switch the device off before you disconnect the field probe. Pull the
connector of the probe firmly with one hand (pulling with the thumb) while you hold the
SMP with your other hand as shown in the pictures below:
Figure 5: Disconnecting the probe
Important: Pull the connector. Don't pull any other part of the probe!
Don't try to turn the probe.
- 9 -

WAVECONTROL SMP Specifications

General

Brand	WAVECONTROL
Model	SMP
Category	Measuring Instruments
Language	English