9 MAINTENANCE
This section explains the maintenance of the apparatus that can be carried out by the user. If you
have any questions about how to maintain the SMP, please consult Wavecontrol.
Maintenance by the user is limited to the outside of the apparatus and its connections. Any
calibration or maintenance that requires the apparatus to be disassembled should be performed by
Wavecontrol.
9.1 Cleaning the apparatus and the screen
To avoid damaging the surface, use soft antistatic wipes to clean the apparatus and the screen.
Use extra care when cleaning the screen, to avoid scratching it.
9.2 Handling the equipment
The SMP and its field probes are not watertight. When using them outdoors, make sure that no
moisture enters the apparatus. Be sure to protect the apparatus from rain.
The apparatus and the probes should also be protected from any strong blows or vibrations.
9.3 Regular recalibration
The SMP does not require recalibration.
Wavecontrol recommends that the field probe/s used with the SMP should be recalibrated
every 2 years. Wavecontrol can recalibrate the probe/s for you. Contact Wavecontrol for
information on the cost and scheduling of recalibration.
- 28 -
To Next Page
Loading...
Need help?
General
