5.4 Memory screen
The memory screen is used to display the distribution of data stored in the different registers.
The screen provides a list of registers with the following information for each register:
• ID: Register identification number.
• Name: Register name.
• Date: Date/Time of start of measurement.
• Samp: Number of points of memory stored in the register.
The number of available points of memory is shown in the upper part of the screen (Free
Memory)
Use the arrows to move through the different registers. When the cursor is on the desired
register press Enter to access to the data stored in the register.
Use the Log/RD key to delete selected register. As a safety measure to prevent accidental loss
of data, you will need to press 2 keys to validate erasure. The procedure is as follows:
o After Log/RD is pressed, the text Delete? and the vertical arrow symbol
↑
appear.
o By pressing the key you gain access to the validation option and the text
Sure? appears.
o To validate the erasure, press Enter.
o To exit the option without erasing, press Back.
Use the Back key to exit the memory screen.
5.5 Memorised data screen
This screen shows a list of the data stored in a given memory register. Each memory point
contains an electromagnetic field measurement with the following data:
• Date / Time: Date and time when the field value was measured.
• Field: Instantaneous field value, showing the field unit.
• Avg.: Average measurement. Below ‘Avg.’, the type of average calculated is indicated.
• Position: If the GPS receiver was enabled when memorisation of measurements was
commenced, a second line will show the position (latitude, longitude and altitude)
where the measurement was taken. If the GPS was enabled when the measurements
were taken but the given position obtained was invalid, the position parameters will be
shown as ‘0’.
Run through the list using the arrows. If the list takes up more than one page, you can
scroll through the list using the keys. To scroll up or down the list quickly, keep the
corresponding key pressed. You can move to the fisrt page of the list from any page by pressing
the key. Equally, you can move to the last page by pressing .
Use the Back key to return to the memory screen.
- 14 -
To Next Page
Loading...
Need help?
General
