Weatronic 12 channel TX module - 7 Using the System with a 2.4 Dual FHSS Micro Series Receiver; General; Dual FHSS Micro 8;10;12 Series Receivers; Receiver Leds and Their Function

16
7 Using the system with a Dual 2.4 Dual FHSS micro series receiver
7.1 General
The Dual 2.4 Dual FHSS micro series receivers are available in 8, 10 and 12 channel versions and can be used as any other ‘normal’ receiver would be
used. In this case the transmitter functions are used to alter the behaviour of the sevos (for example, Dual Rate). However, before use all Dual 2.4
dual FHSS micro servos must be bound to the transmitter before use.
For the more demanding or experienced modeller we have developed our programming program, GigaControl. Using this
program the receiver can be programmed to perform several useful functions, for example, for setting the receiver outputs
to the function which you require, programming servo travel, delayed reaction and sequencing. Unfortunately, the Dual
2.4 Dual FHSS micro series of receivers does not support the multi-servo synchronising feature or the individual servo
voltage settings. For more information, please see Para. 9.
7.2 Dual 2.4 Dual FHSS micro 8/10/12 series receivers
7.2.1 Receiver LEDs and their function
The Dual 2.4 Dual FHSS micro receiver is fitted with 2 LEDs
• 1 green LED labelled “Binding” – “On/Off“
• 1 red LED labelled “Status“
On switching on the system, both LEDs will illuminate briefly.
• Green LED:
LED off -> Receiver switched off
Illuminates solidly -> Connection OK, bi-directional mode
Shoirt flashes-> Uni-directional mode
Slow regular flashes -> Binding
• Red LED:
Flashing -> Failsafe programming active
Further codes/flash combinations -> Not yet allocated
Dual Receiver 2.4 Dual FHSS micro 12