4
Regulatory compliance
EMC compliance USA
FCC Radio Frequency Rules and Regulations
This equipment has been tested and found to comply with the limits for a Class A device, pursuant to Part 15 of the FCC Rules. These limits are de-
signed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment
generates, uses, and can emit radiated radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case
the user will be required to correct the interference at his own expense.
NO MODIFICATIONS. Modifications to these devices shall not be made without the written consent of weatronic Company. Unauthorized modifi-
cations may void the authority granted under Federal Communications Commission Rules permitting the operation of this device.
FCC intentional radiator certification
FCC ID: W3X2754-10 for weatronic Dual Receiver 2.4 Dual FHSS 12-22 R series
FCC ID: W3X2754-20 for weatronic Dual Receiver 2.4 Dual FHSS transmitter module
FCC ID: W3X2754-30 for weatronic Dual Receiver 2.4 Dual FHSS micro series
This equipment contains an intentional radiator approved by the FCC under the FCC ID numbers shown above. These devices comply with Part 15 of
the FCC Rules. Operation is subject to the following two conditions:
(1) These devices may not cause harmful interference, and
(2) These devices must accept any interference received, including interference that may cause undesired operation.
EMC compliance Europe
This equipment meets the requirements of the RTTE and EMC directives.
CE Conformity
This equipment has been developed and constructed in conformance with the current CE regulations and guidelines:
2006/42/EC Machine Directive
2006/95/EC Low Voltage Directive
2004/108/EC EMC Directive
1999/5/EC R&TTE Directive
Safety information
The weatronic 2.4 Dual FHSS Radio Control system is a complex system requiring strict observance of relevant safety rules and guidelines. Before
working with the weatronic RC system, ensure that you are familiar with the system and its operating parts, and with the specific safety instructions
included in this manual.
This manual describes potential hazards you may encounter during operation of this product, but we cannot predict all possible hazards. Safety mes-
sages included in this manual may not represent an exhaustive list, and the guidelines included in this manual should be applied using your judgment
and experience.
Prior to using this equipment, read and observe all safety information and instructions included in this manual. If you are unsure about any of the
potential hazards discussed, contact your dealer or importer immediately.
Read, understand, and follow all safety information contained in these instructions before using your weatronic 2.4 Dual FHSS
Radio Control system. Retain these instructions for future reference.
Intended use
The weatronic 2.4 Dual FHSS Radio Control system consists of modular components. The system is designed for exclusive use of remote controlled
airplane models, model ships and cars and other models.
EMC compliance Canada
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired operation of the device.
Cet appareil est conforme à la norme RSS Industrie Canada exempt de licence. Son fonctionnement est soumis aux deux conditions suivantes:
(1) cet appareil ne doit pas provoquer d’interférences et
(2) cet appareil doit accepter toute interférence, y compris les interférences pouvant causer un mauvais fonctionnement du dispositif.
To Next Page
Loading...
Need help?
General