Webasto Cool Top Trail 20

Cool Top Trail 20/24 14
It is alternatively possible to start and stop the air conditioner
by pushing the touch key
at the air distributor, see chapter
5.16
for more details.
5.7 Setting the temperature
Fig. 24: Setting the temperature
X Use the / keys to change the set temperature.
–
The display of the remote control as well as the display of
the air distributor will show the set temperature.
–
The air conditioner will confirm the receipt of each set
value change with a beep.
–
You may set the temperature between 16 and 30°C while
the unit is running.
–
In FAN
mode no temperature setting is possible.
5.8 Setting the fan speed
Low
level
AUTO
Medium
level
High
level
Automatic
level
Fig. 25: Setting the fan speed
X Use the
FAN
key to set the fan speed level.
–
The fan speed level will directly influence the air flow
volume.
–
Each push on the FAN key changes the fan level in the
sequence as shown in Fig. 25.
AUTO indicates that the Automatic FAN mode is selected. In
this mode the fan speed adapts automatically. Automatic FAN
mode is only available in operation mode COOL or HEAT.
5.9 Setting the operation mode
COOL DRYFAN HEAT
AUTO
Fig. 26: Setting the operation mode
X Press the
MODE
key on the remote control to change the opera-
tion mode. The remote control shows the selected symbols
–
Each push on the
MODE
key changes the mode in the se-
quence as shown in Fig. 26.
C
Fig. 27: COOL mode
COOL mode
–
In COOL mode the air distributor shows the
symbol and
the vehicle will be cooled.
–
Set temperature and fan speed can be selected manually.
–
The compressor will switch off once the set temperature is
reached, it will automatically start up again once the room
temperature setting is exceeded.
C
Fig. 28: DRY mode
DRY mode
–
In DRY mode the unit is reducing the humidity inside the
vehicle.
–
Set the temperature 1°C lower than the current room
temperature.
–
The air distributor shows the
symbol.
C
Fig. 29: FAN mode
FAN mode
–
In FAN mode the indoor air is circulated through the vehi-
cle without heating or cooling.
–
The fan speed can be selected manually.
–
The air distributor shows the
symbol as well as the
current room temperature.
More information https://www.caravansplus.com.au