Cool Top Trail 20/24 16
5.12 Activating the timer
Fig. 34: TIMER Modes
Before activating the timer, select the operation mode, the set
temperature and the desired fan level.
After the start and stop times are set (
see chapter 5.11) one of
the three different TIMER modes can be activated:
1. TIMER
mode
In this mode the unit will switch on at the desired ON time
and keep on running.
2. TIMER
mode
In this mode the unit will stop running at the desired OFF time
and will stay off.
3. TIMER
/
mode
In this mode the unit will start to run at the ON time and stop
running at the OFF time.
This procedure will be repeated every day.
TIMER
10s
Fig. 35: Activating the timer
X Press the
key repeatedly until either the
or
or both symbols are flashing depending on which tim-
er mode is preferred. To confirm the selection wait 10 sec-
onds until the symbol stops flashing and lights up perma-
nently.
–
The clock time shows again.
NOTE
When only the clock shows and no
or
symbol,
the timer is not activated.
5.13 Sleep function
SLEEP
Fig. 36: Setting the sleep function
The sleep function automatically modifies the target tempera-
ture value to provide a pleasant sleeping temperature. It also
helps to reduce compressor run time and thus energy con-
sumption as well as noise levels.
X Press the
key to activate the sleep function.
–
The
symbol in the display of the remote control shows
up to indicate that the sleep function is activated.
–
In COOL mode the set temperature will automatically
increase in two steps and it will have inceased by 2°C after
two hours.
–
In HEAT mode the set temperature will automatically
decrease in three steps and it will have decreased by 3°C
after two hours.
–
The sleep function is only available in COOL or HEAT
mode.
X Press the
key again to deactivate the sleep function.
5.14 Units of temperature change
°C/°F °C/°F
Fig. 37: Celsius / Fahrenheit changeover
X Press the
key to select the temperature units of the
temperature display: Celsius or Fahrenheit.
–
You can do this in any mode.
–
The display on the air distributor follows the selection
made on the remote control.
More information https://www.caravansplus.com.au
To Next Page
Loading...
