Weber mt CR 2 - Maintenance Schedule; Activity and Frequency Table; Engine Manufacturer Compliance

19
8.1. Maintenance overview
Frequency
Initial maintenance /
after 25 operating
hours
Every 8 operating
hours / daily
Every 150 operat-
ing hours / every six
months
Every 150 operating
hours / every year
Every 250 operating
hours
See section
Activity
Change the engine oil
X X
8.2.4
Check the valve play of the
engine, adjust if necessary
X X
Hatz
instructions
Re-tighten all accessible
threaded connections
X
Clean the air lter
X
8.2.1
Change the fuel lter
X
8.2.7
Clean the engine oil lter
X
8.2.5
Check the oil level of
the transmission
X
8.2.8
Change the oil in the exciter
X
8.2.9
The regulations and the operating and maintenance manuals of the engine
manufacturer must be complied with in addition to the activities specied in
the above maintenance overview.
YouTube Playlist - Service Videos