17
6. Transport
Lifting the machine The machine can be lifted for loading onto a vehicle.
Risk of material damage and injuries. The use of defective or
unsuitable lifting gear may cause the machine to fall down.
Use slings that possess the appropriate carrying capacity.
Lock the guide bar in place in the folded position.
Fit the crane hook into the lifting ring and lift the machine
up straight.
7. Storage
Storage at the construction
site
If stored at the construction site, e.g. over night, the machine
must be secured against theft and unauthorized use.
Parked machines presenting an obstacle must be secured in
accordance with statutory regulations, particularly in the area
of public trac surfaces.
Storage for an extended period
If the machine will not be used for a period longer than
one month, the following measures must be taken:
Clean the entire machine thoroughly.
Check the entire machine for leaks. Correct any detected
defects.
Empty fuel and ll the tank with clean fuel.
Check and, if necessary, correct the engine oil level.
Check and clean air and fuel lter. Replace if damaged.
Lightly oil all bare parts, levers and accelerator
control cables.
If the machine is to be stored for longer than six
months, contact the Weber MT’s service organization
to discuss additional measures.
CAUTION
To Next Page
Loading...
