22
2
1
2
3
4
Remove the cover cap from the oil drain valve
Screw the oil drain hose (2) onto the oil drain valve.
CAUTION! Danger of scalding due to hot oil.
Wear protective gloves.
Use extra caution.
Allow the oil to drain into the collection vessel.
Unscrew the oil drain pipe.
Attach the cover cap to the oil drain valve.
Fill fresh oil into the engine in accordance with
the specication.
Check the oil level and top o to the “max.” mark.
Screw in the oil dip stick.
8.2.5. Clean the engine oil lter
CAUTION
Danger of burn injuries at the hot engine and its attachments.
Allow the combustion engine to cool down suciently before
starting work.
Use extra caution during work on the engine when it is at
operating temperature.
Drain the engine oil.
Loosen the fastening screw of the oil lter (1) by
approx. 5 turns.
Grab the screw on the oil lter (2) and pull the lter out of
the engine case.
Blow out the oil lter from inside to outside with
compressed air.
Check the sealing rings (3) for rm seat.
Replace them if they are damaged.
Lightly oil the sealing rings.
Press the oil lter into the engine case.
Tighten the fastening screw. While doing so, ensure that
the tension spring (4) rests on the oil lter.
To Next Page
Loading...
