Weber 300 - Ignition Sequence and Operation

28
IGNITION & USAGE
2
4
8
3
1
3
5
6
7
0''45"35)*.&%*6.-08
*(/*5*0/
Note: Summary ignition instructions are posted on the cart leg under the control knobs.
%"/(&3
'BJMVSFUPPQFOUIFMJEXIJMFJHOJUJOHUIFCBSCFDVFTCVSOFST
PSOPUXBJUJOHGJWFNJOVUFTUPBMMPXUIFHBTUPDMFBSJGUIF
CBSCFDVFEPFTOPUMJHIUNBZSFTVMUJOBOFYQMPTJWFGMBSFVQ
XIJDIDBODBVTFTFSJPVTCPEJMZJOKVSZPSEFBUI
Note : The ignition system ignites the burners with a spark from the igniter electrode
inside the ignition chamber. You generate the energy for the spark by pushing the
ignition button until it clicks.
A) Open the lid .
B) Make sure all burner control knobs are turned OFF . (Push each knob in and turn
clockwise to ensure it is in the OFF position.)
8"3/*/(5IFCVSOFSDPOUSPMLOPCTNVTUCFJOUIF0''
QPTJUJPOCFGPSFUVSOJOHPOUIFMJRVJEQSPQBOFDZMJOEFSWBMWF
*GUIFZBSFOPUJOUIF0''QPTJUJPOXIFOZPVUVSOPOUIF-1
DZMJOEFSWBMWFUIFiFYDFTTHBTGMPXDPOUSPMuGFBUVSFXJMM
BDUJWBUFMJNJUJOHUIFGMPXPGHBTGSPNUIF-1DZMJOEFS*GUIJT
TIPVMEPDDVSUVSO0''UIF-1UBOLWBMWFBOECVSOFSDPOUSPM
LOPCT4UBSUPWFS
%"/(&3
8IFOUIFiFYDFTTHBTGMPXDPOUSPMuGFBUVSFJTBDUJWBUFE
BTNBMMBNPVOUPGHBTJTTUJMMGMPXJOHUPUIFCVSOFST"GUFS
UVSOJOH0''UIFDZMJOEFSBOECVSOFSDPOUSPMLOPCTXBJUBU
MFBTUGJWFNJOVUFTGPSUIFHBTUPDMFBSCFGPSFBUUFNQUJOHUP
MJHIUUIFCBSCFDVF'BJMVSFUPEPTPNBZSFTVMUJOBOFYQMPTJWF
GMBNFVQXIJDIDBODBVTFTFSJPVTCPEJMZJOKVSZPSEFBUI
C) Turn the gas on by turning the cylinder valve counterclockwise .
 8"3/*/(%POPUMFBOPWFSUIFPQFOCBSCFDVFXIFO
JHOJUJOHUIFCBSCFDVF
D) Push in the large control knob for the outside burner and turn it to START/HI .
E1) Q300 with push-button ignition: Push the ignition button, so that it clicks and ignites
the burner . Repeat if necessary.
OR
E2) Q320 with electronic ignition: Push the ignition button . You will hear it click
continually until burner ignites.
F) Check that the burner is lit by looking down through the cooking grate . You
should see a flame.
8"3/*/(*GUIFCVSOFSEPFTOPUMJHIUUVSOUIFCVSOFS
DPOUSPMLOPCUP0''BOEXBJUGJWFNJOVUFTUPMFUUIFHBT
DMFBSCFGPSFZPVUSZBHBJOPSUSZUPMJHIUXJUIBNBUDI
G) After the outside burner is lit, you can turn on the inside burner. Push in the small
control knob and turn it to START/HI . The inside burner will then be ignited by
the outside burner.
X
50&95*/(6*4)
Push in and turn each burner control knob clockwise to the OFF position. Turn gas
supply OFF at the source.
X
5
6