Weber 300 - Burner Tube Cleaning or Replacement

WWW.WEBER.COM
®
33
MAINTENANCE
#63/&356#&$-&"/*/(033&1-"$&.&/5
You will need a flathead screwdriver.
A) Your Weber
®
gas barbecue must be OFF and cool.
B) Turn gas OFF at source.
C) Open lid and remove the cooking grates.
#VSOFS5VCF3FNPWBM
A) Remove the ¼-20 screw that holds the burner tube to the cookbox .
#3PUBUFUIFPVUTJEFCVSOFS4MJEFBOEMJGUCVSOFSBXBZGSPNCVSOFSPSJGJDFBOE
remove from cookbox.
C) Repeat this procedure for the inside burner .
$"65*0/$BSFNVTUCFUBLFOXIFOSFNPWJOHPS
SFJOTUBMMJOHCVSOFSUVCFT%POPUGPSDFPSCFOEUIFHBTMJOFT
UIBUDPOOFDUUIFCVSOFSUVCFTUPUIFDPOUSPMWBMWFT
#VSOFS5VCF$MFBOJOH
A) Look inside each burner with a flashlight .
B) Clean the inside of the burners with a wire (a straightened-out coat hanger will
work) .
C) Check and clean the air shutter openings at the ends of the burners . Check and
clean the valve orifices at the base of the burner valves . Use a steel bristle brush
to clean outside of burners. These actions are to make sure all the burner ports are
fully open.
$"65*0/%POPUFOMBSHFUIFCVSOFSQPSUTXIFODMFBOJOH
D) Lightly tap each burner to get debris and dirt out of the burner tube. Once the
spider/insect screens and burners are clean, reinstall the burners.
#VSOFS5VCF3FJOTUBMMBUJPO
A) To reinstall the burner tubes, reverse steps for “Burner Tube Removal” as previously
described. Check for proper assembly before fastening burner tubes in place.
$"65*0/5IFCVSOFSPQFOJOHTNVTUCFQPTJUJPOFE
QSPQFSMZPWFSUIFWBMWFPSJGJDFT
8"3/*/("GUFSSFJOTUBMMJOHUIFCVSOFSTUIFHBT
DPOOFDUJPOTTIPVMECFMFBLDIFDLFEXJUIBTPBQBOEXBUFS
TPMVUJPOCFGPSFVTJOHUIFCBSCFDVF3FGFSUPi$)&$,'03
("4-&",4u
X
1
2
3
9
8
4
5
7
6