8
GAS INSTRUCTIONS
Put your fi ngers under the front edge of the control panel and lift off.
Completely remove the control panel (4) from the cooking box assembly
exposing the valves, burners, igniter, and manifold.
Remove the Front Panel by sliding the panel up and out of the slots.
(4)
(2)
CHECK FOR GAS LEAKS
DANGER
Do not use an open fl ame to check for gas leaks. Be
sure there are no sparks or open fl ames in the area
while you check for leaks. Sparks or open fl ames will
result in a fi re or explosion, which can cause serious
bodily injury or death and damage to property.
WARNING: You should check for gas leaks every time
you disconnect and reconnect a gas fi tting.
Note - All factory-made connections have been thoroughly checked for gas
leaks. The burners have been fl ame-tested. As a safety precaution however,
you should recheck all fi ttings for leaks before using your Weber Gas
Barbecue. Shipping and handling may loosen or damage a gas fi tting.
WARNING: Perform these leak checks even if your
barbecue was dealer or store assembled.
You will need: a soap and water solution, and a rag or brush to apply it.
Note - Since some leak test solutions, including soap and water, may be
slightly corrosive, all connections should be rinsed with water after checking
for leaks.
Make sure side burner is OFF.
To perform leak checks: open cylinder valve by turning the cylinder valve
hand-wheel counterclockwise.
WARNING: Do not ignite burners when leak checking.
Check for leaks by wetting the connections with the soap and water solution
and watching for bubbles. If bubbles form or if a bubble grows, there is a
leak.
To Next Page
Loading...
Need help?
General
