Weber Summit Owner's Guide

14
2
1
3
4
5
m Always open the lid before igniting the burners.
A) Each control knob has its own igniter electrode built in. To create a spark, you must
push the control knob in (1) and turn it to START/HI (2).
B) This action will generate gas flow and a spark to the burner lighting tube (3). You will
heara“snap”fromtheigniter.Youwillalsoseea3"–5"orangeflamecomingfrom
the burner lighting tube at the left side of the burner (4).
C) Continue to hold the burner control knob in for two seconds after the “snap.”
This will allow gas to flow completely down the burner tube (5) and ensure ignition.
D) Check that the burner is lit by looking through the cooking grates. You should see
a flame. If burner does not light on first try, push control knob in and turn it to OFF.
Repeat lighting procedure a second time.
m WARNING: If the burner still does not light, turn the burner
control knob to OFF and wait five minutes to let the gas
clear before you try again or try to light with a match.
◆
SNAP IGNITIoN oPERATIoN

Weber Summit Specifications

General

Side Burner	Yes
Sear Station	Yes
Rotisserie	Yes
Smoker Box	Yes
Built-in Thermometer	Yes
Burner Material	Stainless Steel
Flavorizer Bars	Stainless Steel
Lid Material	Stainless Steel
Fuel Type	Natural Gas or Liquid Propane
BTU Side Burner	12, 000 BTU
Grate Material	Stainless Steel