Printing
2967530000/00/06.202320
7.4 Avoiding data loss
When recoverable errors occur, the sections that
were completed by the bottom printhead before
the error but not completed by the top printhead
are not repeated. The data from these sections is
no longer available to the printer.
► Avoid predictable error situations.
► To avoid the errors Out of paper or Out of ribbon,
pause the printer before the end of the material.
► After loading new material, continue the print job by re-
leasing pause mode. No data loss will occur.
Pause on ribbon prewarning
With the integrated ribbon prewarning, the occurrence of
the error Out of ribbon can be systematically avoided:
► Select, for example, 35 mm for the remaining diameter
of the supply reel in the parameter Settings > Transfer
ribbon > Ribbon warning.
If the remaining diameter of the supply reel falls below
the set value, the printer automatically switches to pause
mode.
7.5 Perforating
Only on devices with a perforation cutter
► Activate the commands for perforating the material in
the software.
► Adjust the degree of perforation to the material.
If the software does not oer a setting for the
degree of perforation, the adjustment can be per-
formed in the printer conguration.
To Next Page
Loading...
