WEIHONG Ncstudio V15 - Page 103

上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
100 / 116
 P05.00
o Name: AI1 minimum input
o Value: -10
o Range: -10.00V–10.00V
 P05.01
o Name: Rotational speed matching AI1 minimum input
o Value: -100
o Description: 100% speed matches the system maximum rotational speed.
 P05.02
o Name: AI1 maximum input
o Value: 10
o Range: -10.00V–10.00V
 P05.03
o Name: Rotational speed matching AI1 maximum input
o Value: 100
o Description: 100% speed matches the system maximum rotational speed.
 P05.04
o Name: AI1 zero micro-adjustment
o Unit: 1 mv
o Range: -500–500
 P05.14
o Name: AI setting 100% rotational speed
o Value: 3000
o Range: 0 rpm–9000 rpm
 P04.01
o Name: DI1 port function selection
o Value: 1
o Description: Servo enablement
 P04.11
o Name: DI1 port logic selection
o Value: 0
o Description: If it is set to 0, active low. If it is set to 1, active high.
 P04.02
o Name: DI2 port function selection
o Value: 2
o Description: Alarm reset signal
 P04.12
o Name: DI2 port logic selection
o Value: 0
o Description: If it is set to 0, active low. If it is set to 1, active high.
 P04.28
o Name: D08 port function selection
o Value: 2
o Description: Fault output
 P04.38
o Name: D08 port logic selection
o Value: 1
o Range: If it is set to 0, the contact point is NO. If it is set to 1, the contact
point is NC.