______________
Insert checksum: This is special item used for select which kind of checksum will be written into the buffer
when, the Calculate & insert was executed.
Insert address: This is special item that specifies an address from the buffer where a result of chosen
checksum will be written, when the Calculate & insert was executed. Address can not be specified inside the
range <From address> to <To address>. Address is defined as Byte address.
Calculate: Click on the button Calculate starts calculating checksums for selected block in buffer. No writes
into the buffer are executed.
Calculate & insert: Click on the button Calculate & insert starts calculating checksums for selected block in
the buffer and writes the chosen checksum into the buffer on address specified by Insert address.
6.1.10 Show
Switch the mode of buffer data view between 8 bit and 16 bit view. This menu indicates actual data view
mode(8 bit or 16 bit), too.
6.2 Encryption Array
This Sub-menu will appear only if the chip selected is equipped with an encryption array.
It opens the Encryption Buffer edit windows for viewing and editing.
When reading data in the main buffer will be the Exclusive-NORed with the encryption table.
The result will be displayed in the buffer.
6.3 Edit Configuration\User code
This option is available for certain devices only.
Option pertaining to the active device can be set.
It is only entered as HEX codes. The result of edit will be displayed in the buffer. It can be saved with data file.
After saving file and you can read next file & you need not change configuration parameter again.
Tianjin Weilei Techonlogy Ltd.
www.weilei.com TEL:022-83945122
FAX：022-83945121 2018-03-08
To Next Page
Loading...