weilei Wellon - Getting Started; Installing the USB Driver

______________
3. Getting Started
3.1 Check
Your package should include a programmer, a connecting cable, a power cable or an AC adapter.
If your device is specific package other than DIP, please choose an adapter.
3.2 Installing
Insert the installation disc into a driver (CD-ROM). Installation program will run automatically.
Connect the AC adapter to the programmer’s power jack. Then connect the programmer module to the
computer’s USB port with the provided cable
3.3 Installing the USB driver
Note : (1).Please install the software of WELLON programmer by inserting the installation disc into CD-ROM
driver, before you install the USB driver of WELLON programmer module.
(2) Insert USB cable port vertical to the programmer’s USB port when connect the programmer to the
computer’s communication port.
Connect the programmer module to the computer’s USB port with the provided cable.
WINDOWS system will note finding new hardware and auto install the USB driver. If system
can’t find the driver, you can find it by yourself. This driver is available in CD-Rom or
Defaults. ( C:\weilei\ WELLON \usbsys or C:\weilei\WELLON\usbsys64).
If the programmer is not detected follow the below given procedure.
WINDOWS operating system
1. Turn on the computer.
2. Connect the programmer module to the computer USB port with the provided cable.
3. Show Found new hardware Wizard, search `No, not this time`, Press the <Next> button.
Tianjin Weilei Techonlogy Ltd.
www.weilei.com TEL:022-83945122
FAX：022-83945121 2018-03-08