______________
8. Run
8.1 Program
This command programs the device in the socket with the contents of the memory buffer.
Pressing <ENTER> at ‘Program’ or clicking this option will begin the programming operation. During this
operation the progress will be displayed on the screen.
If the option is successful, a ‘Program OK!’ message will be displayed, otherwise an error message will be
displayed.
WARNING:
Do not remove the device until this option is complete, as it may damage the device.
8.2 Read
This command reads the contents of the device into the memory buffer.
Note that after data has been read into memory, the same size or smaller device type may be selected
without altering any data stored.
This option can be selected from the menu.
Pressing <ENTER> at or clicking the ‘Read’ selection will begin the read operation. The progress will be
displayed on the run-time screen. If the operation is successful, a ‘Read OK!’ message will be displayed,
otherwise an error message will be displayed.
WARNING:
Do not remove the device until this option is complete, as it may damage the device.
8.3 Verify
This command verifies that the content of the device is the same as the contents of the memory buffer. You
can use this command to verify that a device has been read, and that the read operation was successful.
WARNING:
Do not remove the device until this option is complete, as it may damage the device.
8.4 Blank Check
This command verifies that the device has not been programmed.
You can start the blank check operation by clicking the option on the menu, by pressing <ENTER> when the
option is selected on the menu.
If the device is blank, a message ‘Blank check OK!.’ will be displayed on the run-time viewer screen.
If the device is not blank, an appropriate message will be displayed.
Tianjin Weilei Techonlogy Ltd.
www.weilei.com TEL:022-83945122
FAX：022-83945121 2018-03-08
To Next Page
Loading...