______________
WARNING:
Do not remove the device until this option is complete, as it may damage the device.
8.5 Compare
This option compares the data in the device with the current data in the memory buffer.
If any differences are found, they will be displayed in the active window.
8.6 Auto
This function will execute several functions in a sequence. Generally, it executes Blank check, Program and
Verify. For a PLD, it executes the Erase function at the beginning and sets the Security bits at the end.
This command can be selected from the menu, or by pressing the hot-key <F8>.
8.7 Security
This feature applies to PLDs and Micro controllers equipped with a security function. If the security is set, the
data programmed into a chip will not be read correctly.
Note: Lock, Protect, etc also mean Security dependent on Device. After which the security device could pass
blank check.
8.8 Encryption
This applies only to some Micro controllers. This will program the content of the encryption table onto the
encryption array of a chip. The content of the encryption table can be loaded, saved and edited. Once
encryption is completed the data in the main buffer will be the Exclusive-NORed data with the encryption
table.
8.9 Program Configuration
This option is available for certain devices only.
In the Edit Configuration\User code, you can set configuration.
8.10 OTP security
This option is only used for the series of AT89C51/52. It forbids to unprotect.
Note that after running this option, the device will not be programmed again.
8.11 SVF
This option is available for certain devices only. The user must select the chip with SVF function. At the same
time, other options can’t be used. This type chip must be used SVF format file, open the file, click the SVF
button, and then the function is complete.
Tianjin Weilei Techonlogy Ltd.
www.weilei.com TEL:022-83945122
FAX：022-83945121 2018-03-08
To Next Page
Loading...