______________
sum of projects are displayed in the first line. If current project is the enabled project, there will be a “<En>”
follow the numbers. At right side of the first line, displays the target count of current project. If no target count,
displays zero. The second line displays the manufacture of the device. The third line displays the type of
device. And the forth line displays the name of current project. Press “↑” key or “↓” key(or
on
the touch screen). The LCD will display different projects’ information. Press “→” key or “←” key. The
displayed contents will move right or left. Press the “ESC” key(or
on the touch screen). The
programmer will be back to “Chip Programming” status.
If there is no project in the programmer, it will display “NO PROJECT!” and then go back to “Chip
Programming” status.
CAUTION: When the programmer is programming chips, do not enter “Display Project List” status.
When the programmer is not at “Chip Programming” status, do not press the “Run” key. Otherwise, mistakes
may happen.
9.2.6 Operate Project
When the programmer is at “Display Project List”, press the “ENTER” key(or
on the touch
screen). If current project is not protected by password, the programmer goes into “Set Project” status and
displays a tool menu. The content of the menu is according to the properties of current project. If the project
is not enabled, the menu only has the “Project Enable” command. If the project is enabled, two commands
will be displayed. They are “Read” command and “Verify” command. And if the target count of the project is
not zero, one more command “Count Change” will be there. Press “ESC” key(or
on the touch
screen). The programmer will go back to “Display Project List” status.
(1) Project Enable
Select “Project Enable” in the menu and press “ENTER” (or on the touch screen). The
programmer displays “Project Enable” interface. At this time, if the user selects “No” and presses
“ENTER” key(or
on the touch screen) or presses “ESC” key(or on the touch screen)
directly, the programmer will go back to “Set Project” status. If the user selects “Yes” and presses
“ENTER” key(or on the touch screen), the programmer begin to enables current project. Those
projects which are protected by password only can be enabled by this way.
(2) Change Target Count
Use “↑” key or “↓” key(or on the touch screen) to select “Count Change” menu and
press “ENTER” (or
on the touch screen). The programmer displays “Count Change” interface.
Press “ESC” key(or
on the touch screen), the programmer will go back to “Set Project” status.
At one time, the user can only input one number. Press “↑” key or “↓” key to change the number and
press “→” key to input it. Then, repeat this operation to input other numbers. Pressing “←” key can
delete the last input number. The range of target count is from 1 to 39996. When finish it, press
“ENTER” key, the new data will be saved. (Using the keyboard on the touch screen can input the
number directly).
(3) Read
Put a chip in the socket of the programmer, and use “↑” key or “↓” key(or
on the touch
Tianjin Weilei Techonlogy Ltd.
www.weilei.com TEL:022-83945122
FAX：022-83945121 2018-03-08
To Next Page
Loading...