4 | EN Ⓒ weinor GmbH & Co. KG
Ⓒ weinor GmbH & Co. KG EN | 5
4.4.1 Icons in the device display 18
4.4.2 Status LED 20
4.4.3 Group control unit and master channel (All) 21
4.4.4 Joystick (multidirectional key) 22
4.4.5 Selection button 22
4.4.6 OPEN, DOWN and STOP keys 24
4.5 Menu mode 24
4.5.1 "Administration" menu 26
4.5.2 "Settings" menu 27
4.5.3 "Function" menu 30
4.6 Programming the transmitter 32
4.6.1 Programming additional transmitters 33
4.6.2 Synchronous programming mode 35
4.6.3 Stopping programming mode in transmitter 35
4.6.4 Approaching end positions of roller shutter,
awning, venetian blind 35
4.6.5 Programming the intermediate position in
the receiver 37
4.6.6 Programming the ventilation/tilting position in
the receiver 37
4.6.7 Operation of transmitter with Combio JA Pulse 38
4.6.8 Deleting positions/deleting transmitters 39
4.6.9 Expert settings 40
4.7 Changing the batteries 40
4.8 Cleaning and care of the device 40
5 EC Declaration of conformity 41
6 Troubleshooting 42
7 Repair 43
8 Address 43
9 Disposal 44
1 General information
1.1 Notes on the operating instructions
The contents are arranged by the life phases of the
MultiTel 2 radio remote control (referred to below as
the "device").
The manufacturer reserves the right to make changes
to the technical data in the operating instructions. They
may differ from the actual model of the device without
fundamentally changing the basic information and losing
validity. The current status of the technical data can be
requested from the manufacturer at any time. Claims
based on the above will not be accepted. Deviations from
statements in the text and illustrations are possible and
will depend on the technical development, equipment
and accessories of the device. The manufacturer will
provide information on special models with the sales
documentation. Other information will remain unaffected
by the above.
1.2 Standards and Directives
The basic occupational health and safety requirements of
the applicable laws, standards and directives have been
incorporated into the design. The safety of the device is
confi rmed by the declaration of conformity (see Chapter 5,
EC Declaration of Conformity). All information on safety in
the operating instructions are based on the current laws
and regulations applicable in Germany. All information in
the operating instructions must be observed at all times.