Welbilt Convotherm 4 - How to Fully Automatically Clean the Oven Cavity Using the Single-Dose Dispensing Bottle

5.2.2 How to Fully Automatically Clean the Oven Cavity Using the Single-dose
Dispensing Bottle
For your safety when working with/on the combi oven
Before starting work, read and understand the rules, risks, and hazards specified in the 'For Your Safety on page 17' section
and in these instructions and follow all the corresponding instructions without exception.
Procedures that you must be familiar with
You will need to be familiar with the following steps:
■
Safely Opening and Closing the Unit Door
41
■
Emptying the Loading Trolley's Condensate Collecting Tray 91
■
Adding Cleaning Agent from Single-Measure Dispensing Bottles to the Inside of the Oven Cavity 100
Handling single-dose dispensing bottles
■
Make sure that the work surface does not come into contact with cleaning agent or rinse aid.
■
Do not put empty single-measure dispensing bottles down on the work surface, as drops of cleaning agent or rinse aid
may run down along the outside of the bottles.
■
W
ear the required personal protective equipment
Prerequisites
■
Y
ou must be familiar with how to use the software to such an extent that you will be able to access and start the various
cleaning profiles, please refer to the combi oven's operating instructions.
■
The unit and the accessories being used do not have any obvious damage.
■
The supply lines installed for electrical power, water, and wastewater do not have any obvious damage, have a secure fit,
are not dripping anywhere, and appear to be safe and fully functional after a visual inspection.
■
All food must have been taken out from the oven cavity. There must not be any foreign objects inside the oven cavity.
■
All bakeware, sheet pans, and shelf grills, as well as any other accessories, must have been taken out from the oven
cavity.
■
The oven cavity drain must be clear. It must not be clogged or blocked by any residues. The strainer on the oven drain
must be in place.
■
The condensate collecting tray on the loading trolley must be empty.
■
The empty loading trolley must be inside the oven cavity.
■
The unit door's inner glass door must be properly locked in place.
■
The suction panel is properly locked in place.
■
The unit door must be closed.
■
You must supply the fluids required by the cleaning program you will be using. Please refer to 'Supplying Cleaning
Agents' on page 67.
How to Fully Automatically Clean the Oven Cavity Using Single-Measure Dispensing Bottles (easyTouch)
1.
Open the cleaning profile and start the cleaning sequence.
2.
Follow the software's prompts.
■
If the oven cavity is being pre-heated, wait for the pre-heating to end
and then continue to step 4.
■
If the oven cavity is being cooled down, continue to step 3.
5 How to Clean the Combi Oven
Operating Manual 70